Matek Systems GNSS M9N-5883 NEO-M9N GPS Module With Magnetic Compass QMC5883L Support GLONASS, Galileo for FPV RC Racing Drone

    M9N-5883 uses multi-constellation GNSS powered by u-blox NEO-M9N , NEO-M9N is a concurrent GNSS receiver which can receive and track multiple GNSS systems. Owing to the multi-band RF front-end architecture all four major GNSS constellations, GPS,Galileo, GLONASS and BeiDou can be received concurrently.

More details about the NEO-M9N, pls check out u-blox NEO-M9N page

Description:

Brand: Matek Systems

GNSS u-blox NEO-M9N (GPS, GLONASS, Galileo and BeiDou)

Magnetic Compass QMC5883L

Patch antenna 25*25*4mm

Input voltage range: 4~6V (5V pad/pin)

Power consumption: 50mA

Operating Temperatures: -20~80 °C

UART(TX, RX) interface for GNSS NEO-M9N

I2C(DA, CL) interface for Compass QMC5883L

JST-GH-6P connector

3.3V Power LED, Red

GNSS PPS LED, Green,  blinking(1Hz) when GNSS has 3D fixed

32mm*32mm*10mm

14.5g

Wiring and settings

* M9N-5883 5V to Flight controller 4~6V

* M9N-5883 RX to Flight controller UART_TX

* M9N-5883 TX to Flight controller UART_RX

* M9N-5883 CL to Flight controller I2C_SCL

* M9N-5883 DA to Flight controller I2C_SDA

* M9N-5883  G  to Flight controller GND

* Compass Alignment(Arrow forward and flat mounting):

   INAV/BetaFLight: CW 270° Flip when flight controller arrow is facing forward also

   Ardupilot/Mission Planner: Rotation None

* Protocol: Ublox or NEMA

* Make sure to have compass/magnetometer 10cm away from power lines/ESC/motors/iron based material

* The scratches on ceramic antenna are the result of tuning the antenna.

* u-center Windows

STL and STEP

M9N-5883_step.zip

M9N-CAN_shell_STL.zip

Tips

ArduPilot supports NEO-M9N well

INAV2.5 ublox/ublox7/NEMA all don’t support NEO-M9N for now. new protocol is required in INAV2.6

Betaflight UBLOX protocol doesn’t support NEO-M9N,  Pls select NEMA protocol & Auto Baud.

Mateksys GNSS series comparison

Package included:

1x M9N-5883

1x JST-GH-6P to JST-GH-6P 20cm silicon wire