Specifications:

Frequency:5.8G

Channel:48CH

Power:0/100/200/400/1000mW

Voltage:DC7-26V100mw(230mA)/200mw(290mA) Current:400mw(360mA)/1000mw(490mA)

Supply Voltage:4V-17

Vclarity:CMOS 700TVL

Focal Length:1.4 mm

Antenna:RP-SMA (external thread Inner hole)

Volume:30×20×5mm

Weight:36g

 

User Guide:

1. LED indication:

The red LED indicates the state of working mode or the item when setting the VTX (flashing 1 time means selecting the channels, flashing 2 times means selecting the bands, flashing 3 times means selecting the power levels).

The blue LED indicates the state of Pitmode or the value of item when setting the VTX( e.g. when selecting the channels, 3 times offlashing means channel 3.When selecting the bands, 3 times of flashing means band C.As for the item of power levels,3 times of flashing means at the power level of 400mW).

2. Working mode indication:

-After powering up, the red & blue LEDs will signal the following three items of VTX in turn: chan- nel, band and power level(the flashing times of the red and blue LEDs indicate the item and the value respectively). After that, the LEDs indicate the working modes.

-Nomal: The red & blue LED are on.

-Pitmode: Use two short press to tum on/off the transmitting(PITMODE setting) and then the Red and Green LEDs will be twinkles. When power is set to OFF(PITMODE is effective), you can set bands and channels without interference to others.The AV transmitting distance is only within 1-2 meters when it is in Pitmode.

-Press the button twice will toggle the ON/OFF of Pitmode.

3. Setting:

-Press and hold the button until the red LED flash 1 time which means the item of channel selecting, then press the button can select the channels(blue LED flashing times corre- sponds to the channel 1-8).

-Press and hold the button again, the red LED will flash 2 times which means the item of band selecting, then press the button can select the band(blue LED flashing times corre- sponds to the band A-R).

-Press and hold the button again, the red LED will flash 3 times which means the item of power level selecting, then press the button can select the power(blue LED flashing times corresponds to the power level).

-Finally, press and hold the button, save and exit the setting of VTX(This step is essential for setting).

-Press the button twice will toggle the ON/OFF of Pitmode.

 

Note:

1.Make sure that there is enough space for airflow when installing the module on the drone.

2.Please install the antenna before powering up ,otherwise there is a risk of burningICs.

3.The maximum current of output DC 5V is 500mA.

4. Smartaudio cannot be adjusted at the same time as PWM or keys.The reconstruction of the flight control will write the default parameter again into the VTX and make the parameters invalid.

5. Please set the parameters in accordance with the local laws and regulations.

 

Package included:

1 x 1W VTX Camera Combo